Making a Bong / How to make a bong
 Would you like to test my new bong? Here is a way to get high by making a bong
Instructions -- 1. Make a hole for the pipe about 1/3 way up bottle and insert pipe so pipe is bending down into the bottle. 2. Put the socket in the end of the pipe outside the bottle 3. Make a smaller hole in the bottle above the first hole 4. Fill bottle with water so that pipe is in water, but water level does not reach the hole.
You need:
* A plastic coke bottle
* A small piece of piping – 5/10cm
* A socket from a socket set that will fit in the end of the pipe
* A knife
Ok. The socket is where you put your mix(tobacco and your crumbled solid) and the second hole acts as an air-hole. When you have filled the socket with your mix, you light the mix and suck through the bottle top while holding your finger over the air-hole.
To clear the bottle, either suck all the smoke out or take your finger off the air-hole and blow the smoke out. So there you have it, a simple bong.
Link: weedguru
|
Add Feedback